In order to control Cinegy Multiviewer players audio, please use the Mutliviewer Control Utility - see attached.

In order to run the utility follow the steps:

1. Unpack the archive and copy the utility to any station.
2. Run the utility.
3. In the Server IP field enter the IP of the Cinegy Multiviewer station. If Cinegy Multiviewer is running on the same station – enter 127.0.0.1.
4. Press "Connect". If Cinegy Multiviewer is not running there, the Status field will show the "Not available" message.

When it is connected, in the Layout area you will see the list of available layouts. When clicking a layout (or using shortcuts F1-F10) you will see all available Players and Audio channels accordingly. It is possible to switch between players using 1-10 key buttons.